Characteristics
Body Sugaring Roll-on with activated carbon 100ml
Activated carbon is a particularly popular ingredient in skin care products and is obtained by processing various natural materials, most commonly bamboo and coconut husk. It is a black, odorless powder with beneficial properties for the human body and is suitable for cosmetic use as it has significant benefits for the skin.
It deeply cleanses the skin, detoxifies it and acts as a natural exfoliator. It removes dead cells from the skin, helping it to “breathe”, while at the same time promoting cell renewal, giving the skin a smooth texture and a healthy appearance.
INGREDIENTS
SUCROSE, GLUCOSE, GLYCERIN, AQUA (WATER), CITRUS LIMON (LEMON) JUICE, CI77268:1
INSTRUCTIONS
HEATING
Professional Heater:
1) Remove sticker from roll-on applicator.
2) Insert the roll-on into the slot.
3) Plug the heater in.
4) Heat it for approximately 30 minutes.
Bain-Marie:
1) Remove sticker from roll-on applicator.
2) Place the roll-on in hot water and make sure no water comes into contact with the product or else its efficiency will be reduced.
3) Heat it for:
10 minutes (if the roll-on is full)
5 minutes (if the roll-on is half full)
Micro-wave:
1) Remove sticker from roll-on applicator.
2) Place the roll-on in the center of the oven, in a standing position.
3) Heat it in medium wattage for:
30 seconds (if the roll-on is full)
15 seconds (if the roll-on is half full)
. The above mentioned times can vary depending on the temperature, the type of oven and the quantity of the product that is left in the roll-on.
MORE ABOUT HEATING
. If the product is not in the appropriate liquid form you can heat it more, otherwise, if it is over- heated just let it cool down. (Make sure it can be easily applied)
. During the session, replace the roll-on in the heater/hot water/oven (depending on the heating method) in order to keep the product in liquid form.
. If the roll-on applicator is very hot to hold, wrap it in a strip before picking it up.
ALWAYS CHECK THE TEMPERATURE OF THE PRODUCT BEFORE USE BY SPREADING A THIN LAYER ON THE BACK OF YOUR WRIST!
CAUTION:
. Do not overheat it because its efficiency will be reduced and burning may be caused.
. In case that hot product comes in contact with your skin, rinse off immediately with cool water.
APPLICATION
With roll-on applicator facing down, squeeze slightly and roll on a strip (in one direction only), until an even layer of sugar wax is dispensed. Now roll-on applicator is ready to use.
. Spread a thin layer of sugar wax using the roll-on applicator in the direction of the hair growth.
. Place a strip on the thin spread layer and press for proper sticking. Leave lower section of strip 2cm from the skin to ensure easy removal with no sticky fingers.
. With one hand stretch the skin out. With the other one remove the strip quickly, in the opposite direction of the hair growth and parallel to the skin using rapid movements to reveal a perfectly soft and hair-free skin!
. At the end of the session, rinse with water to remove any leftovers.
Reviews
There are no reviews yet.