Characteristics

Wax Roll-on titanium 100ml

Wax Roll on titanium is perfect for sensitive or tanned skin. It spreads easily and accurately in thin layers, removes even the shortest hair from the root and ensures a perfect and long-lasting depilation, leaving the skin extra soft and silky smooth for many weeks…

Additional Information

Ingredients

Glyceryl Rosinate, Mineral Oil, Beeswax, Microcrystalline wax, Titanium Dioxide, BHT, C.I. 26100

Instructions

HEATING

Professional Roll-on Heater:
1) Remove sticker from roll-on applicator.
2) Insert the roll-on into the slot.
3) Plug the heater in.
4) Heat it for approximately 20 minutes.

Micro-wave:
1) Remove sticker from roll-on applicator.
2) Place the roll-on in the center of the oven, in a standing position.
3) Heat it in medium wattage for:
30 seconds (if the roll-on is full)
15 seconds (if the roll-on is half full)
. The above mentioned times can vary depending on the temperature, the type of oven and the quantity of the product that is left in the roll-on.

MORE ABOUT HEATING
. If the product is not in the appropriate liquid form you can heat it more, otherwise, if it is over- heated just let it cool down. (Make sure it can be easily applied)
. During the session, replace the roll-on in the heater/oven (depending on the heating method) in order to keep the product in liquid form.
. If the roll-on applicator is very hot to hold, wrap it in a strip before picking it up.
ALWAYS CHECK THE TEMPERATURE OF THE PRODUCT BEFORE USE BY SPREADING A THIN LAYER ON THE BACK OF YOUR WRIST!

CAUTION:
. Do not overheat it because its efficiency will be reduced and burning may be caused.
. In case that hot product comes in contact with your skin, rinse off immediately with cool water.

APPLICATION
With roll-on applicator facing down, squeeze slightly and roll on a strip (in one direction only), until an even layer of sugar wax is dispensed. Now roll-on applicator is ready to use.
. Spread a thin layer of wax using the roll-on applicator in the direction of the hair growth.
. Place a strip on the thin spread layer and press for proper sticking. Leave lower section of strip 2cm from the skin to ensure easy removal with no sticky fingers.
. With one hand stretch the skin out. With the other one remove the strip quickly, in the opposite direction of the hair growth and parallel to the skin using rapid movements to reveal a perfectly soft and hair-free skin!
. At the end of the session, use oil to remove any leftovers.

AFTER USE
. If you have not used all the product, keep the roll-on applicator in a standing position, in a cool, dry place until you use it again.